Today i rebuilt a hope bulb i got from ebay, fitting my short axle for the frame mount systems.
It arrived with a skewer stuck inside.Its about 1" in on one side and protrudes a couple of mil on the other.
The skewer is jammed in tight,and i mean tight,there is no way on gods earth its going to come out.I've supported the axle in my big vice and tried hammering the skewer rod through,its not moving not at all :shock:
Easier to just replace the axle.
After assembly,i thought the freehub was sitting a mill or two further out than it should :?
So like a complete amateur i pulled off the freehub
Ping went the pawls and springs .
I've found the 3 pawls and 2 of the springs but the last is eluding me.
It arrived with a skewer stuck inside.Its about 1" in on one side and protrudes a couple of mil on the other.
The skewer is jammed in tight,and i mean tight,there is no way on gods earth its going to come out.I've supported the axle in my big vice and tried hammering the skewer rod through,its not moving not at all :shock:
Easier to just replace the axle.
After assembly,i thought the freehub was sitting a mill or two further out than it should :?
So like a complete amateur i pulled off the freehub
Ping went the pawls and springs .
I've found the 3 pawls and 2 of the springs but the last is eluding me.