- Feedback
- View
As I discovered this afternoon after a long absence from having to do it....
Should have just been a quick case of undoing the lock nuts and cones to move the spindle across as it protruded beyond the drop out a tiny bit (QR hub), ended up thinking may as well regrease the thing even though it felt smooth (one cone is loose anyway)
2 hours, tons of swearing, discovery of ripped up and pitted cones later.... :evil: :evil: Did the best I could but still can't quite get the bl***y spindle dead central and I ended up giving up and putting it to one side again, seriously thinking of rebuilding wheel onto a sealed bearing hub....
AAAARRRRGGGGHHHHHHHHHHHHHHHHHHH!! So what's your most hated job...?
Should have just been a quick case of undoing the lock nuts and cones to move the spindle across as it protruded beyond the drop out a tiny bit (QR hub), ended up thinking may as well regrease the thing even though it felt smooth (one cone is loose anyway)
2 hours, tons of swearing, discovery of ripped up and pitted cones later.... :evil: :evil: Did the best I could but still can't quite get the bl***y spindle dead central and I ended up giving up and putting it to one side again, seriously thinking of rebuilding wheel onto a sealed bearing hub....
AAAARRRRGGGGHHHHHHHHHHHHHHHHHHH!! So what's your most hated job...?