Just built a bike for my son, used some spare wheels I had (mavic crosstrail). On fitting rotors to the rear, 2 of the 6 bolts wimt tighten fully, they spin when they should stop/be tight. Bolts are new and thread locked, hubs dont show any signs of a crack around the bolt holes, though by design the holes aren't fully enclosed (weight saving I assume).
Is there anything I can do.other than apply more threadlock and hope? I dont want them to fail in use.
Mavic are trying to be helpful but have advised to retap. Not sure this will help though. They dont have spares for the wheel, so I'm hoping a solution can be found that doesn't require a new set of wheels.
Any ideas/solutions that have worked for anyone with a similar issue?
Is there anything I can do.other than apply more threadlock and hope? I dont want them to fail in use.
Mavic are trying to be helpful but have advised to retap. Not sure this will help though. They dont have spares for the wheel, so I'm hoping a solution can be found that doesn't require a new set of wheels.
Any ideas/solutions that have worked for anyone with a similar issue?