Removing mangled limit screw?

[FluffyChicken]

Hammer and trox didn't work, I did get it move 1 full turn before I sheared the off what was left of the bolt head. Going to try and get the needle nose in from the bottom now.

All valid ideas cheers but I'm limited to standard tools, no heat, no power tools apart from the dremel. Might see if dermal do a reverse drill bit if the pliers don't work.

Cheers all.

The Dremel would need to reverse for ti to be able to use a reverse drill bit.
I've not seen one that does.
You could however drill with a 1mm or so bit and see if it moves it, drill it, make a wreck of the mech.

Get something penetrating in their now you can pool it?
Take the other limiter out now and remove the plastic bit too.
might be a bent screw though.

 

[MADB]

Got the little swine out, had to sacrifice the black plastic part. Putted the plastic part out and then made a mini cutting wheel for the dremel and cut out a part for a small screwdriver. Doesn't look that bad now it's out.



Looks nice.

 

[smashinstella]

Re:

Congratulations, you have found one of the most powerful tools in anyones tool box........ PATIENCE !
good job there !