Pace RC200 F3

Keeping it central is the problem I have with the basic threaded bar and plastic disc one. I've got a technique that works where I tighten a bit and use a rubber mallet to line the cup back up but a steel frame is a bit more tolerant of a mallet.
 
I have finally made some progress!

Stripped down the 16" one for some key parts for the silver one, although when I gathered everything together, I had more than I realised

Untitled by Mac74, on Flickr

Getting the steerer out the RC36 was a battle but I should have realised that it would be too short for the 18" frame, so I've gone as far as I can for now.

Untitled by Mac74, on Flickr
 
Just tidying up and have the spec list:

Frame: Pace RC200 F3 18"

Fork: Pace MXC Crown with RC30 mk2 legs

Headset: CK 1" Nothreadset
Stem: 1" Controltech Ahead
Handlebar: Pace Renthal RC130 purple
Grips: Onza Ules
Barends: X-lite stubbies

Brakes: Suntour XC Pro front and XC SE Self Energising Rear
Brake Pads: Suntour
Brake Cables: Various - Some Shimano SIS outers
Cantilever cable hangers: Generic Purple Anodised
Brake Levers: Suntour XC-Pro

Shifters: Suntour XC-Pro Thumbshifters
Front Derailleur: Suntour XC-Comp
Rear Derailleur: Suntour XC-Pro
Derailleur Cables: Clarks
Cassette: Shimano M737
Chain: KMC Gold 9Spd
Cranks: Raceface Turbine
Crank Bolts: Campag
Chainrings: Pace 26, 38, 47 (Need to check this)
Chainring bolts: Raceface
Bottom Bracket: Edco square taper
Pedals: M737SPD or unbranded purple flat cage

Hub Skewers: Unbranded Purple Anodised
Rims: Mavic 217
Hubs: Hope Tiglide rear, CK Front
Nipples: Unbranded
Spokes: Stainless
Tyres: Panaracer Smoke/Dart Classic
Tubes: Generic 26x1.75

Saddle: Selle Italia Flite Alpes
Seatpost: Thomson Elite Inline 29.4 x 410mm
Seatpost Binder: Pace

Weight: TBC
 
Back
Top