Re:
I know theres a few Hope fans here, so looking for a bit of advice... I have an issue with a Hope Mono Mini front brake.
The brake had been sat around for a while, and needed bleeding when I first fitted it.
All worked fine, but after a few weeks I'd have to nearly pull the lever back to the handlebar to get decent braking, oddly if I pumped the lever a lot or just carried on using the brake it did seem to improve a bit.
I assumed it was air trapped in the system after I bled it, so bled it again, and did get some air out.
Now however theres not much lever travel at all before the lever stops, but the braking power is poor, the braking feels "wooden" , as if the pads are contracting the rotor but theres just not much power behind them.
I would mention the front lever, when pulled, stops, then if you pull harder it sort of makes a creaking noise/feeling, the rear lever doesn't make any noises.
I have a spare set of the same brakes, so might swap bits around this week.