MacRetro chat and rides thread

Re:

Rob, does it have a swingarm and shock like this?

17afce4fea5e4ad29a673b99c5cdc5f9.jpg


Or is the swingarm like the more usual later one on my Super V 1000SL with the shock virtually horizontal?

clubby, my memory is telling me someone told me the guy at Edin Bike Co-op left and was working elsewhere but cannot remember where though. It is my memory I'm talking about so it could just be a load of pi.....
 
Re:

No, more like yours but it can't take disc brakes. I'll try Google for a image.
 

Attachments

  • Screenshot_20190922-225821_Chrome.webp
    Screenshot_20190922-225821_Chrome.webp
    238.7 KB · Views: 856
Re:

This is the one I sold that was then sold on again, Super V900...
Should be similar to your Rob, I think the only difference might be the rear shock, Fox Alps 4 or 5R.
 

Attachments

  • Screenshot_20190923-082429-360x509.webp
    Screenshot_20190923-082429-360x509.webp
    30.1 KB · Views: 841
Re:

Aye Rob, that's what I hoped you'd have. The thing is you could easily fit a Lefty to your frame and ditch the existing shock for a modernish air one. That's what I ended up doing with mine all be it I was forced in to it when I discovered original cast/bonded swing-arm was cracked. I fitted a Jekyll swing-arm, frame already had a Fox air shock, and in the time I was waiting for swing-arm to turn up found a Lefty and wheel cheapo on ebay. I think the fitted Headshok it had, an air/oil shock, only had 70mm of travel compared to the over 100mm on rear, so the 100mm Titanium Lefty balanced it up a bit better. Nice comfy capable XC bike but able enough to ride down less extreme DH. Unlike the guy on board. :facepalm:

Do you want/trust :mrgreen: me to have a look at Headshok for you?
 
Re:

Had a look at my head shock today, got the top bit off with the Park Pin pliers :)
But below that is a spacer, bottom out bumper, then another two pin the cap, I've seen a YouTube video where they used right angle circlip pliers to undo it, so I just need to find mine and then I should be able to get to the top out bumper and main elastomer underneath.
 
Re:

Sounds like the same tool as mine took. I found it too deep to get my circlip pliers into. It also took a decent amount of force to tighten down again afterwards.
 
Back
Top