Hope pro 2 Evo hub help

ishaw

Gold Trader
GT Fan
Feedback
View
I've got an unhealthy collection of spare hubs so thought I'd set about them today and see what's what, replace bearings etc.

Replaced the bearings on one set, all good, but on another I am not sure what's going on.

It was complete with an alloy freehub, well I say complete, it's missing the little washer they sits between the freehub and inner bearing so I need one of those.

After replacing the hub bearings, I swapped out the alloy freehub with a steel one after replacing the bearings in there too (all lovely skf).

Once reassembled there seems to be very little axle sticking out of the freehub end, there will be even less with the washer, hardly anything for the end cap to seat over.

What have I done wrong?
 

Attachments

  • PSX_20250315_191506.webp
    PSX_20250315_191506.webp
    63.1 KB · Views: 2
  • PSX_20250315_191530.webp
    PSX_20250315_191530.webp
    120.7 KB · Views: 2
looks to me like you haven't pushed the freehub body on all the way, at the bottom of the freehub there is a plastic seal ring, sometimes black sometimes green, these pop back in to the shell, Hope do a specific tool to help locate that part, it can be done without it but it's easier with the tool, and it's only cheap

tool is HTT1003-06S, it;s listed at pro2/4 seal tool and it's £11.50 at retail toolhope.webp
 
Back
Top