Hope disc timeline

[The Ken]

No sorry, I meant the hub is a bolt on, and uses a bolt either side that sits in a recessed cap that tightens on the outside of the dropout, I only have one, and its a bit rough.

Pretty sure it is just an m5 standard bolt if it is the bolt I think it is... just don't use ally ones

 

[big.eck]

is it the bolt itself or the big spacer thing ?

Both x 2. Ill take a pic

i don't have the spacers but i might have something else whic looks almost the same

 

[jamabikes]

 

[big.eck]

have you still got the axel ? these use a 9mm through axel

 

[The Ken]

you need a 9mm through axle for that - I use a specialized one but any fit.

You also need either the caliper mount or a spacer, I got a basic axle spacer and a couple of washers for free from my lbs for when I don't have the caliper mounted.

 

[Rod_Saetan]

∆∆∆ yes.

 

[Rod_Saetan]

i don't have the spacers but i might have something else whic looks almost the same

i mean:

∆∆∆ yes.

 

[big.eck]

i don't have the spacers but i might have something else whic looks almost the same

i mean:

∆∆∆ yes.

i was thinking you still had the axle theres a few 9mm through axles on the market , all should fit if it was just the spacers i was gona see about using a set of these > http://cgi.ebay.co.uk/Halo-Hex-Key-Skew ... 1e5f9a4416 and just drilling the center hole to take an m5 bolt

 

[The Ken]

your 5mm drill will be wider than those "axels" eck - they are standard QR size - got a set for miniKen


Just realised what you mean - they might not even need drilled, if I was at home I'd try it out for you.

 

[big.eck]

your 5mm drill will be wider than those "axels" eck - they are standard QR size - got a set for miniKen


Just realised what you mean - they might not even need drilled, if I was at home I'd try it out for you.

ave got one sitting in the cave i'll never use so i don't mind drilling it :twisted: