- Feedback
- View
The headshock on my recently acquired F700 has no boing whatsoever.
Are they a pig to rebuild?
Are parts available?
Ta
Are they a pig to rebuild?
Are parts available?
Ta
Do we have a resident C'dale headshock expert?
- Thread starter Grannygrinder
- Start date
- Feedback
- View
Re:
Thanks
Just need a source of parts then.
Thanks
Just need a source of parts then.
- Feedback
- View
strips of roller bearings!
- Feedback
- View
Re:
Sounds fun!!
Sounds fun!!
- Feedback
- View
Are parts still available? Or anything that would work
I could fit reducer cups and go rigid.....but i like a little bit of bounce!!
I could fit reducer cups and go rigid.....but i like a little bit of bounce!!
Trialsmeister
Retro Guru
- Feedback
- View
Re: Re: Head-ache
If you're as optimistic after a rebuild, I've got one here that also needs working on!
There's a good bit of information contained in this thread.
http://www.retrobike.co.uk/forum/viewto ... h#p2743315
There was a Tech at Edinburgh Bicycle, in Alvanley Terrace, who had the castle tools for them, I'm not sure if he/they are still there.
I'm a long way off having the time to start on mine, so any findings would be pilfered unashamedly!
All the best,
Mike
Grannygrinder":1702v0jw said:
If you're as optimistic after a rebuild, I've got one here that also needs working on!
There's a good bit of information contained in this thread.
http://www.retrobike.co.uk/forum/viewto ... h#p2743315
There was a Tech at Edinburgh Bicycle, in Alvanley Terrace, who had the castle tools for them, I'm not sure if he/they are still there.
I'm a long way off having the time to start on mine, so any findings would be pilfered unashamedly!
All the best,
Mike
parts here https://qwertycycles.co.uk/collections/headshock?page=3
and loose needle rollers in case the strips aren't around https://simplybearings.co.uk/shop/Loose ... index.html
and loose needle rollers in case the strips aren't around https://simplybearings.co.uk/shop/Loose ... index.html
Re:
Cannondale never sold the required tools to the public so they are hard/expensive to source.
Also the x4 needle bearings strips are all different thicknesses..you will need a micrometer to order the right ones. :? They vary by a few thousands of an inch !
Cannondale never sold the required tools to the public so they are hard/expensive to source.
Also the x4 needle bearings strips are all different thicknesses..you will need a micrometer to order the right ones. :? They vary by a few thousands of an inch !
