And today I did......
- Thread starter kaiser
- Start date
The Ken":2gwcdxx6 said:Eck could you not adapt one of the wheels to make a rear - might need to be SS - then you would have the worlds first 4 disc bike setup
i've thought about it and it could be done quite easily "goes away to put thinking cap on"
big.eck":u6nejnla said:The Ken":u6nejnla said:Eck could you not adapt one of the wheels to make a rear - might need to be SS - then you would have the worlds first 4 disc bike setup
i've thought about it and it could be done quite easily "goes away to put thinking cap on"
Velo solo do a bolt on sprocket which fits disc mounts Dr S":s5q2t1by said:big.eck":s5q2t1by said:custom whole set-up , got it mostly planned in ma head so just a case of spending some pennys
Have you thought about piston sizes? you will need to get the ratio between the slave and master cylinders bang on or it will have poor lever feel. Another solution would be two master cylinders in the lever.
i'd given it a little thought , if i use a pair of c2's with a newer ti6 master cylinder using a double banjo bolt right at the lever it should be ok...
i'm planning on cutting the mounts off one side of a c2 and moving them across and welding them back on to use on the right leg
or as gary said , i've been looking at motorbike brakes :twisted:
- Feedback
- View
Sorry to be off topic
Eck, have you not seen the San-An in the classifieds??
I text you earlier
http://www.retrobike.co.uk/forum/viewtopic.php?t=88310
G
Eck, have you not seen the San-An in the classifieds??
I text you earlier
http://www.retrobike.co.uk/forum/viewtopic.php?t=88310
G
enid_puceflange":3s0yp4z2 said:Sorry to be off topic
Eck, have you not seen the San-An in the classifieds??
I text you earlier
http://www.retrobike.co.uk/forum/viewtopic.php?t=88310
G
wifes got ma phone
just spotted it , very very tempting.........if only seller was closer :roll:cheers for the heads up tho
- Feedback
- View
I bet if it was a Silver ,8 incher , you would have been all over it
G
G
