Search results

Re: Hi Does jump frame take disc? Cheers Matt

6 Saracen frames, two Marin frames and a Kona frame. Must get on with building up some complete bikes!

A rusty 1990 Marin Bear Valley frame and forks This should be a challenge, stuck post, seized bottom bracket and top tube dent!

I've had some success in the past by hammering / tapping on the top or bottom of the dent. Use a metal working hammer lightish weight to tap the raised area where the paint has chiped off in the OPs picture, whilst holding another hammer or a dolly (if you can get hold of one) on the bottom...

Cool Paypal ok? which email do I send payment to Thanks Matt

Hi Are any of the hubs still available? Interested in the Mavic Rear 28h has been used as ss £7 and Mavic rear 32h 126mm £13 Will you take £17 for the two? Cheers Matt

Sounds good Post up a pic when it's done.

I bid on that. Nice frame and some good parts. I thought it was fixable, worst case scenario argos will repair or replace the drop out. But it's costly. I would second TIGing it. Glad that you're not binning the frame.

I've emailed you re the Platform pedals, untidy but would be nice stripped and polished. £9.

Here's my Ebay bankrupt Saracen frame that I converted to 69er I had to consider fork axle to crown so as not to mess up the geometry. I thin the A/C is 425mm. It rode well!

I've use chemical metal filler in the past. It's very simular to car body filler.

Are the Magura brakes still available?? If so I'm interested in those please. Cheers Matt

I've recently used some Montana spray cans and had a reasonaly good result. The cans are good value from Ebay shops and are harder wearing than the car paint aerosols from the likes of Halfords which I've tried in the past. The paint is suitable for all surfaces including metal and is...

I'll give that a go. I can true the wheel so that it runs central in the seat stays but the wheel is slightly off centre on the chain stays. This is not by a huge amount maybe 3 - 5mm.

Hi Folks Could anyone tell me whether a 1993 Kona Cindercone would have asymetric chainstays? I built up a wheel, trued it central to the hub then fitted it in the frame and noticed that it wasn't central in the stays. Is this normal or are the stays bent? There's no sign of a bend...

Hi I have one of these hubs that I built up into a front wheel. I bought it very cheaply from Ebay. The hub will fit a standard 20 mm fork and use a standard calliper with a bit of fettling Contact Hope they will make you a disc rotor. However there may be some clearance issues...

Here are some close ups as promissed of my bankrupt Saracen frame. Before and after End result Some heat shrink (available from B&Q) added to keep the mud out. Be carefull of the paint. My thin layer of rattle can paint wasn't able to cope. Next job strip down and powder coat.

Yes it's a short length of outer. Took a bit of trial and error to get it to the correct length. About an inch and a 1/4.

I managed to fit V brakes to mine by moving the noodle that is attached to the frame. You need to get something like a ratchet bit holding screw driver without the bit in it to fit over the end of the noodle. Carefully bend the noodle so that it curls around the seat tube. This lines the...

Yeah probably worth doing if you're stripping the frame. Disc tabs etc would make a neater job than the adaptor. I love these old Kona frames mines a 1993. It's a lovely ride great geometry and light weight too. Worth holding on to and modernising I think.