richardf Retro Guru Aug 19, 2023 #1 Any idea? Just worried about cracking the weld if I go too high on the handlebar bolt. Was getting slippage at about 8nm, so gone up to 12nm now.
Any idea? Just worried about cracking the weld if I go too high on the handlebar bolt. Was getting slippage at about 8nm, so gone up to 12nm now.
mdvineng Senior Retro Guru Feedback View Aug 19, 2023 #2 Cinelli 1A were 18Nm for the quill and 15Nm for the clamp. That's an Ally stem though but the Ti should at least cope with those figures.
Cinelli 1A were 18Nm for the quill and 15Nm for the clamp. That's an Ally stem though but the Ti should at least cope with those figures.
F ferrus Breezer Fan Feedback View Aug 19, 2023 #3 I can’t remember if the bolts in those are titanium but if so, best to replace with well greased steel. Ti bolts in Ti threads are horrible.
I can’t remember if the bolts in those are titanium but if so, best to replace with well greased steel. Ti bolts in Ti threads are horrible.
G gripper Dirt Disciple Oct 18, 2023 #4 Was it ok at 12nm ? Will be fitting one myself soon and also don't want to over tighten .
