Spooky Rear Disc Mount Adapter

[sectionate]

Yeah, I think they would too. Seen quite a few posts asking about them.

All it needs is a few good dimensions and I should be able to get something made up. I have even messaged Frank the Welder on Instagram to see if he has old plans for them

 

[Bullpup]

Is the Spooky a 22mm mount? I have a Schwinn Homegrown with a Hayes caliper fitted.

 

[Bullpup]

This may be of interest: viewtopic.php?f=3&t=337057

 

[Bullpup]

Images previously supplied by dirtydozen:
https://hosting.photobucket.com/albums/ ... 70067b.jpg
https://hosting.photobucket.com/albums/ ... 3660f1.jpg
http://i1070.photobucket.com/albums/u48 ... 5cdf1c.jpg
http://i1070.photobucket.com/albums/u48 ... 15e64e.jpg

 

[Bullpup]

This may be a more workable solution:
viewtopic.php?f=2&t=67566&start=0

 

[Bullpup]

Or this: viewtopic.php?f=1&t=119330

 

[sectionate]

Images previously supplied by dirtydozen:
https://hosting.photobucket.com/albums/ ... 70067b.jpg
https://hosting.photobucket.com/albums/ ... 3660f1.jpg
http://i1070.photobucket.com/albums/u48 ... 5cdf1c.jpg
http://i1070.photobucket.com/albums/u48 ... 15e64e.jpg

Does he have photos of the adapter that converts the 22mm holes from the vertical face to the horizontal face of the Lower stay? I have one of the a2z adapters on order, I just need the other widget bit

 

[sectionate]

Is the Spooky a 22mm mount? I have a Schwinn Homegrown with a Hayes caliper fitted.

Yes it’s 22mm, but the holes are on the wrong face of the stay and an adapter is needed

 

[Timoth27]

Re:

Didn’t hope do a c2 calliper for that mount aswell. It used 1 of the bolts that clamp the calliper together as a mounting hole to get the clearance on the seat stay. Still required that little mounting bracket thought. I seem to remember a dekerf thread with one on here a couple of years ago.

 

[d8mok]

Re:

Yeh that’s I’ve got fitted caliper No 1 I think (not sure without looking) . If you using that Hope caliper you still need the hope mount hbrm165h (and the spooky bit)