Re: Rocky Mountain "Syncros" Expérience
thx for your comments/compliment. i'll be "updating" again soon. :facepalm:
but only out of necessity. the bb axle length that is spec'd for the cranks is supposed to be 107mm. but because of the short wheelbase, if i'm in granny gear, the front mech cage is rubbing against the outer edge of the rear tyre nobbies when i make a turn. so i'll have to swap in another Syncros Ti bb with 113mm axle to hopefully clear that problem.
while i'm at it, i will prob make a few minor tweaks as well to shift some Syncros gear from this bike to yet another RM project by subbing in with other Syncros replacements. over-all it will pretty much remain the same, as i love it the way it is.
ever changing, ever evolving with me. :roll:
thx for your comments/compliment. i'll be "updating" again soon. :facepalm:
but only out of necessity. the bb axle length that is spec'd for the cranks is supposed to be 107mm. but because of the short wheelbase, if i'm in granny gear, the front mech cage is rubbing against the outer edge of the rear tyre nobbies when i make a turn. so i'll have to swap in another Syncros Ti bb with 113mm axle to hopefully clear that problem.
while i'm at it, i will prob make a few minor tweaks as well to shift some Syncros gear from this bike to yet another RM project by subbing in with other Syncros replacements. over-all it will pretty much remain the same, as i love it the way it is.
ever changing, ever evolving with me. :roll: