Replacement MCUs or solid elastomers for old skool forks

johndeverill

Senior Retro Guru
Some of you might have been following what I'm up to. Right I think we're ready to go! These
are Mk1 Pace RC35 MCUs. Red are hard, yellow are medium and orange are top out bumpers. 10mm top out gives approx 50mm travel with medium MCUs. Full set will be £27.50 or mix (I.E full set of medium + 4 hard or vice-versa) will be £35. To mix and match the originals like that would be £80-90 new! Can also supply a 50g tub of nice slippy silicone/PTFE grease for £6. I can also make 25mm, 22mm, 21mm, 19mm or 16mm diameter versions for other forks with 10mm, 6mm or 5mm ID holes. Can also be solid elastomers rather than MCU. Service of forks and installation an option too. These are made to order and will take approx. 10 days for delivery as the rubber takes 7 days to mature....like a good wine or whiskey! PM for more info.
 

Attachments

  • 20200215_153643_compress22.jpg
    20200215_153643_compress22.jpg
    782.9 KB · Views: 581
  • 20200215_102341_compress8.jpg
    20200215_102341_compress8.jpg
    1.6 MB · Views: 581
  • 20200215_153615_compress32.jpg
    20200215_153615_compress32.jpg
    1.6 MB · Views: 578
  • 20200215_163455_compress10.jpg
    20200215_163455_compress10.jpg
    1 MB · Views: 561
:cool: will look to get some when i get around to rebuilding my pace forks.

Will also definatly have a couple of sets for my Judy's.
 
Re: Re:

johndeverill":2hnxm06o said:
Hi, no probs. Do you have any measurements for the judy ones? Cheers


Ah, no, measuring mush is a bit tricky :LOL:
 
Back
Top