Removing paint from a vintage silca pump

[Mod-Master]

To be on the safe side wet and dry.

 

[dirttorpedo]

To be on the safe side wet and dry.

What do you think about steel wool and some vinegar?

 

[Mod-Master]

Probably nice to start out rough

But end smooth.

 

[dirttorpedo]

So i tried steel wool and rubbing alcohol last night and had some luck. Unfortunately the paint on the pump handle is different / harder than the paint on the tube. I'll try and take a photo tonight.

 

[dirttorpedo]

Here’s my progress with steel wool and rubbing alcohol

 

[Mod-Master]

are the logos engravings? I could maybe even suggest a Dremel with wire wheel for the handle?

 

[dirttorpedo]

are the logos engravings? I could maybe even suggest a Dremel with wire wheel for the handle?

The logo on the tube is raised and made with some gold material (paint perhaps?) and the logos on the handle are raised and molded into the piece. It will be difficult to keep the handle logos in good condition and remove the paint using my current approach.

 

[Mod-Master]

Ah, if it feels like it could flake off, then just take it slow, take your time, as I don’t think anyone remakes these decals.