My unicorn - 1994 Kona Hei Hei - FULL SPEC/FINISHED PICS ON PAGE 8 & 9 - BOTY 2021, BOTM April 2021 & 2nd MucOff Show & Shine Malverns Classic 2021

[44Racing]

Re:

Unfortunately I’m still awaiting the final sourced parts to arrive in order to get on with the final build, so I’ve just been resorted to tweaking bits here and there.

 

[44Racing]

Re:

Unfortunately I'm still waiting for the final parts to arrive for this, so I'm still tinkering with it at the moment.

 

[Rich]

Re:

Gotta get me a Disc Drive...cracking build mate

 

[44Racing]

Re: Re:

Gotta get me a Disc Drive...cracking build mate

Cheers buddy, it’s really appreciated

Disk Drives are cool and getting rarer and rarer all the time.

 

[dyna-ti]

I see no spokey dokeys :?

 

[44Racing]

I see no spokey dokeys :?

If they’d get stuck on the snowflake spokes

 

[romanrinos]

Bring it on! Looking forward to seeing the whole build finished and a proper ride review!

 

[44Racing]

Bring it on! Looking forward to seeing the whole build finished and a proper ride review!

Hopefully won’t be too long mate...I’m literally waiting for 3 small parts to arrive in order to finish it, but until these arrive I can’t go any further at the moment.

Full build is looking to be 22-23lbs

 

[44Racing]

Re:

So after around a 4 month wait the final bits have arrived back after being re-anodised. They were all NOS parts, however 25 years of shop soiling left them with a finish that my OCD wasn't happy with. These parts were;

NOS Ringle Holey seat clamp
NOS Ringle Zooka top cap
NOS Kona Dog Bone rear cable guide
NOS Kona seat clamp

Despite not using the Kona seat clamp on this build (at present) I got it re-anodised as well so it was ready if needed as I am still not 100% sure if I like the look of the Ringle Holey seat clamp.

Before they are fitted I am just waiting for 2 raw titanium bolts to arrive for the seat clamp and top cap.

Some of the parts need a good dust :roll:

 

[Magpiegifts]

Re: Re:

So after around a 4 month wait the final bits have arrived back after being re-anodised. They were all NOS parts, however 25 years of shop soiling left them with a finish that my OCD wasn't happy with. These parts were;

NOS Ringle Holey seat clamp
NOS Ringle Zooka top cap
NOS Kona Dog Bone rear cable guide
NOS Kona seat clamp

Despite not using the Kona seat clamp on this build (at present) I got it re-anodised as well so it was ready if needed as I am still not 100% sure if I like the look of the Ringle Holey seat clamp.

Before they are fitted I am just waiting for 2 raw titanium bolts to arrive for the seat clamp and top cap.

Some of the parts need a good dust :roll:

Awesome! Top job Sir.
I'm after a zooka top cap also, where did you locate yours to?