Marzocchi FS - IS disc brake adaptors.
- Thread starter Rampage
- Start date
- Feedback
- View
Re:
I was thinking 160mm or 180mm. Happy with either.
I was thinking 160mm or 180mm. Happy with either.
romanrinos
Kona Fan
Howdy, a couple of queries:
- are these still at £25 a pop, or still dependant on order numbers fulfilled?
- re: older dual mount Z1s. Are there any plans to make a mirrored adapter for a right side fitting?
- are these still at £25 a pop, or still dependant on order numbers fulfilled?
- re: older dual mount Z1s. Are there any plans to make a mirrored adapter for a right side fitting?
Second prototype - 3D Printed.
Disc is a 160mm, as it is an Avid caliper it needs the cup and cone washers. Other calipers shouldn't need this.
I will also make an add-on part that will let you use a 180mm or 185mm disc. Are 180mm and 185mm still in use?
They will be made out of laser cut stainless steel, aluminium doesn't have as good a finish for laser cutting (nor water jet cutting).
Edge finish will be similar or maybe a bit worse than the part in the picture below.
The offset and the drilling and taping of the four holes will need to be done on a milling machine.
I may get them chemical blacked, it will give a dull black finish to them, what do you think?
Disc is a 160mm, as it is an Avid caliper it needs the cup and cone washers. Other calipers shouldn't need this.
I will also make an add-on part that will let you use a 180mm or 185mm disc. Are 180mm and 185mm still in use?
They will be made out of laser cut stainless steel, aluminium doesn't have as good a finish for laser cutting (nor water jet cutting).
Edge finish will be similar or maybe a bit worse than the part in the picture below.
The offset and the drilling and taping of the four holes will need to be done on a milling machine.
I may get them chemical blacked, it will give a dull black finish to them, what do you think?
- Feedback
- View
Quality workmanship and as for pulling endo’s on a plastic pre-pro brake adaptor takes the biscuit
romanrinos":33w5ahuc said:
No idea on price, hopefully similar. I'm not holding anyone to anything.
The parts I get laser cut can be machined to fit either side. I don´t know how the caliper would fits on the other side, is there a specific caliper they made for it?
romanrinos
Kona Fan
Top drawer work! I quite like the green too! 
The blackened finish I reckon would look smart and give it a professional finish.
Re: otherside for the olderside of the twin tab, I saw another post on here with someone asking this, but unless i'm missing something, I also dont understand why you couldn't just use the same fitting and bolt from the other side?
Formula still make 80mm rotors as i have two here (not sure if 85s are common with other manufacturers?) so would be good to cater for both sizes if possible?
The blackened finish I reckon would look smart and give it a professional finish.Re: otherside for the olderside of the twin tab, I saw another post on here with someone asking this, but unless i'm missing something, I also dont understand why you couldn't just use the same fitting and bolt from the other side?
Formula still make 80mm rotors as i have two here (not sure if 85s are common with other manufacturers?) so would be good to cater for both sizes if possible?
Similar threads
