Wanted Little plastic cap for a steerer

[fiveSixteenths]

Anyone have one that would fit this Marin stem?
I brought a bar end cap by mistake lol and while it sort of fits, well, you know. Happy to swap(!) or sell if you wanted a matching Marin pair. It’s mint and would be a fiver posted. Which makes this a saleWanted thread. Apologies mods

 

[Rotorhead]

Ah sorry Richard I obviously put you on to the wrong thing. I'll have another rummage tomorrow.

 

[fiveSixteenths]

No, it’s ok! It very nearly does the job, was my gamble lol but if you do happen on one, would be lovely.
In other news, it probably might help if I noted the tube diameter! About 21mm on the inside. My vernier battery has died so measuring is a little vague. I tried an ITM one and that was too small.

 

[Gtpulse]

Sorry I don’t have one but I do remember from a couple of previous attempts to find one that I think the ones that fit these have the cap part at an angle to the bung/finned part if that makes sense. So a bar end type one ends up slightly proud of the top.

 

[fiveSixteenths]

Sorry I don’t have one but I do remember from a couple of previous attempts to find one that I think the ones that fit these have the cap part at an angle to the bung/finned part if that makes sense. So a bar end type one ends up slightly proud of the top.

Exactly this, and that helps add to the ‘specific nature of the thing to fit another thing’ should anyone happen on bits of stem-top-shaped-single-use-plastics

 

[fiveSixteenths]

Saturday nite feverish bump

 

[Gtpulse]

One here https://www.ebay.co.uk/itm/Retro-Ma...2349624.m46890.l49286&mkrid=710-127635-2958-0 not mine, comes with a stem though! Depends how badly you need it to be complete I guess!

 

[Rank_21]

Would one of those Zoom caps work? Or too slanted

 

[marc two tone]

Got one here, a genuine 1992.
Do you reckon itll fit?