Been giving some thought on how to mount one of these standard torches to my handlebars and my first idea to try is as follows...
Going to source a small length of plastic cable conduit, with a slightly smaller id than the od of the torch shaft, and then cut a thin slot along its length. This should then grip the shaft (ohh, err ) of the torch. Will also need to add some thin rubber to the inside of the conduit to give sufficient grip, and to allow the csk bolts I'm going to use to mount this to pull up under flush.
Then going to drill a couple of 4.5mm holes through the counduit and then spot these holes through onto my existing light holder . Will then drill, tap and M4 hellicoil the existing holder to hold the conduit.
All works a treat in my mind but will update on real-life progress
Going to source a small length of plastic cable conduit, with a slightly smaller id than the od of the torch shaft, and then cut a thin slot along its length. This should then grip the shaft (ohh, err ) of the torch. Will also need to add some thin rubber to the inside of the conduit to give sufficient grip, and to allow the csk bolts I'm going to use to mount this to pull up under flush.
Then going to drill a couple of 4.5mm holes through the counduit and then spot these holes through onto my existing light holder . Will then drill, tap and M4 hellicoil the existing holder to hold the conduit.
All works a treat in my mind but will update on real-life progress