Klein 'Burn Victim' is right up my alley! Keep as is!
If ever a Klein was in need of a refurb...!
- Thread starter nausea
- Start date
27motorhead
Old School Grand Master
- Feedback
- View
I was waiting for that. Assume you'd built it up as it is, and congratulate him on finding a very original Klein paint finish!
Last edited:
nausea
Retro Guru
The old paint came off pretty easily. Unsurprising perhaps as it was just slapped on with no primer. Some of the original black paint remains around the welds but this probably just serves to smooth these areas off even more so no bad thing.
Of course much huffing and puffing was endured getting the bottom bracket out but managed to employ a stack of Mavic hub bearings, some headset spacers, a crank bolt, a prop shaft coupling and a headset press to good effect!
Some minor issues with the frame... A couple of ferrules are fused in the ends of the internal cable routing. I suspect just inserting an un-ferruled outer cable into these would pose no problems. One bottle boss has sheared off - no attempt to remove it yet so we'll see how that goes. The headset came out a little too easily for my liking but I have a deeper cup headset to replace it with so this should install snugly enough.
Always nice to see a paintless Klein - their welding work is really something. I'll give it the once over with some finer sandpaper and then it will be time for a few coats of etch primer...
Of course much huffing and puffing was endured getting the bottom bracket out but managed to employ a stack of Mavic hub bearings, some headset spacers, a crank bolt, a prop shaft coupling and a headset press to good effect!
Some minor issues with the frame... A couple of ferrules are fused in the ends of the internal cable routing. I suspect just inserting an un-ferruled outer cable into these would pose no problems. One bottle boss has sheared off - no attempt to remove it yet so we'll see how that goes. The headset came out a little too easily for my liking but I have a deeper cup headset to replace it with so this should install snugly enough.
Always nice to see a paintless Klein - their welding work is really something. I'll give it the once over with some finer sandpaper and then it will be time for a few coats of etch primer...
Attachments
nausea
Retro Guru
Very interesting that you mention hand painted lettering... I think I might have a stab at that actually seeing as the Klein logo is pretty chunky. I remember seeing a Salsa logo that had been handpainted on here once. Here are a couple of examples of my painted sign writing work. Much of it was done using masking so not the full on traditional method but there is a fair amount of freehand work in there.
Attachments
nausea
Retro Guru
Here it is in its built up state... It's was recently replaced as my cycling-to-the-shops bike by a similarly uglified sub 20lb Scott Scale Premium with Pace RC30s as I wanted something silly light!I was waiting for that. Assume you'd built it up as it is, and congratulate him on finding a very original Klein paint finish!
