2020 Transition Spur

rigidftw

Retro Guru
I've got this thing in late 2020 and it is one great piece of kit.

The frame and fork came from Switzerland, barely used by the previous owner, which seemed to be more sensible than getting a complete bike and changing most of its parts to my liking.
I did not think this through though. Import taxes were eye-watering.
But apart from a annoying creak coming from the seatpost (30.9mm post w/ shim in 31.6mm seat tube), that I could fix just by changing to a dropper post with the correct diamerer it's been faultless.

p6pb19897054.jpg


p6pb19930671.jpg


p6pb19930672.jpg


p6pb19930674.jpg


p6pb20078877.jpg


p6pb20173985.jpg


p6pb20264354.jpg



p6pb20264356.jpg


p6pb20369739.jpg


The 36t chainring I used initially proved to be too big for both the frame and the kinematics. I rubbed the clear cote off the chainstay and sitting down up a climb it tended to bob around A LOT.
I changed it to a 34t chainring and there have been no further issues.

...apart from the SID Ultimate fork that I got with the frame. Within in 3 months it had developed quite a lot of bushing play, Ultimately the lowers were replaced by SRAM/Rockshox, I sold the fork and went with a 120mm Pike Ultimate instead.

p6pb20400577.jpg
 
Last edited:
I occasionally changed the stem, bars, seat and pedals but overall it had stayed relatively unchanged since August 2021.

p6pb25689929.jpg


And what fun is that?

So I decided to take off the trouble-free drivetrain and convert this thing to singlespeed.

But not the easy way with the tensioner in place of the rear derailleur. The tensioner needs to be mounted to the ISCG tabs.
 
What a weapon. I’ve a Sentinel and have often thought of adding a Spur as a shorter option. Great handling bikes Transitions.
 
This is version three.

p6pb26238490.jpg

p5pb26238489.jpg

p5pb26238491.jpg



This time the bracket will be printed by proper company specialising in 3D printing, instead of friends with DIY printers.
And maybe, if I'm lucky, the design changes improved the part enough for it to hold up fine, despite not being made from metal.
 
p6pb26268661.jpg


p6pb26268664.jpg


p6pb26276749.jpg


p6pb26276751.jpg


p6pb26276752.jpg


p6pb26276756.jpg



Couple of challenges: Lots of chain growth, chain skipping on the King cog and it seems I put too thick of a grease inside the freewheel mechanism, so that the spring behind the ratchet is held back a little.

The rear pulley was also changed for a bigger one with narrow-wide tooth profile. Seemed like a good idea.
 
Last edited:

Latest posts

Back
Top