Have a oneup rad cage I want to fit. Usually you just remove the inner cage and jockets, then unscrew the bolt holding the outer cage to the body. On the m980 the cage 'bolt' doesnt have any allen key fitting so I'm not sure how to get it off.
It has a clutch, but after removing the clutch cover, there is still no obvious way of removing it.
Anyone done this?
The rad cage I have was fitted to an m980 mech that was damaged, and it came off the normal way I.e. allen key through the bolt. Assume this is part of the rad cage kit, just cant remove the old one.
Anyone any ideas?
It has a clutch, but after removing the clutch cover, there is still no obvious way of removing it.
Anyone done this?
The rad cage I have was fitted to an m980 mech that was damaged, and it came off the normal way I.e. allen key through the bolt. Assume this is part of the rad cage kit, just cant remove the old one.
Anyone any ideas?
