WTD Dura Ace crank
- Thread starter Archster
- Start date
Agreed, ideally 7410 flavour
Square taper. I'm actually looking at 600 / ultegra at the minute, this period mid 90's seems to be where the cross over from 600 to ultegra occured ?
As some units are labelled both 600 Ultegra ?
The cost of the DA stuff is obscene, baring in mind the technology that's trickled down over the past two decades prob renders this in the same category nowadays as 105 ?
The rest of the bike is DA but I'm swaying off onto a more cost effective method ?
Square taper. I'm actually looking at 600 / ultegra at the minute, this period mid 90's seems to be where the cross over from 600 to ultegra occured ?
As some units are labelled both 600 Ultegra ?
The cost of the DA stuff is obscene, baring in mind the technology that's trickled down over the past two decades prob renders this in the same category nowadays as 105 ?
The rest of the bike is DA but I'm swaying off onto a more cost effective method ?
only bargain I see on ebay aus http://www.ebay.com.au/itm/Shimano-Dura ... 27cba16f28
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Not sure on spindle length as yet ?
It's a 7410 DA one so I suspect the correct length etc ?
I had seen that one and watching with interest ?
I don't imagine for one Minuit tho that it will be such a bargain by the time the auction ends, I might replace the whole lot with newer bottom end and cranks ?
It's a 7410 DA one so I suspect the correct length etc ?
I had seen that one and watching with interest ?
I don't imagine for one Minuit tho that it will be such a bargain by the time the auction ends, I might replace the whole lot with newer bottom end and cranks ?
I have 1055 NOS 170mm chainsets in at the moment complete. 53T/39t as well. 52T/39T are available too.
I can lay my hands on new 7400 cranks but without rings. Expensive though (~£100). I can get new 7400 big rings too but the inners would have to be 105 and I habe some of those as well.
I can lay my hands on new 7400 cranks but without rings. Expensive though (~£100). I can get new 7400 big rings too but the inners would have to be 105 and I habe some of those as well.
Well it ended at 53 pounds and change http://www.ebay.com.au/itm/170920079144 ... _cvip=true
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
