K Kerry Retro Newbie Oct 27, 2021 #1 Got some nice betd rocker plates for the stinky but not sure which bolt hole to use as there are two. Any ideas chaps Thanks. Attachments 20211027_131553.webp 96 KB · Views: 2
Got some nice betd rocker plates for the stinky but not sure which bolt hole to use as there are two. Any ideas chaps Thanks.
novocaine Retro Wizard Oct 27, 2021 #2 from memory, inner is 1" more rear wheel travel than outer one, pre load on shock needs to adjusted to suit. Again this is from a very distant memory but I think inner was 6" outer, was 5" in line with stock plates.
from memory, inner is 1" more rear wheel travel than outer one, pre load on shock needs to adjusted to suit. Again this is from a very distant memory but I think inner was 6" outer, was 5" in line with stock plates.
K Kerry Retro Newbie Oct 27, 2021 #3 Novocain. I think your right. With the same preload it's easier to compress on the inner hole. Outer it is then. Thank you.
Novocain. I think your right. With the same preload it's easier to compress on the inner hole. Outer it is then. Thank you.
Thanks.
