Wanted Williams chainset 3 pin,

[Brigallen]

Wanted williams 3pin chainset in reasonable condition for retro build. sorted.

 

[cipolinni]

williams

Hi Brigallen
Don't know if your interested in the following
I have a N.O.S Williams 52 tooth chainring.Dated 1955 (C1000) Model
Also a very nice 5-pin Milremo Chainset (Cottered) 46 tooth
let me know
Malc

 

[Banashapan]

do you mean 'sorted' as you now have some cranks?

just to let you know I have a set of 3 arm williams cranks 170mm length, surplus to my requirements- they have a single 49t chainring, chrome is in reasonable condition, but would need a little elbow grease if you want them to look close to new!

If theres any interest I can post some pictures.

cheers,

Banashapan

 

[DonaldM]

HI there,

I'm new to this forum. I've just acquired a tandem which someone has sawn the cranks off from the stokers position. It's a Williams 3 pin job and I need the arms and 3-pin star.

Anyone got a suitable set?

Kind regards, Donald

 

[DonaldM]

Hi again, Here are some pictures of the intact and cut cranks.

 

[readview]

Looks like a C34,you could do to measure the other cranks length so you dont end up with different lengths on the same axle.I think they came as a 6 1/2 inch or 6 3/4 inch.

 

[DonaldM]

Many thanks for your reply Readview. Is the measurement from the inside of the two holes or the overall length?

Unfortunately the poster above has sold his parts so still on the look out.

Regards, Donald