Univega DS Swinging arm bushes

wavendene

Retro Newbie
Hello there.
I have a 1997/8 Univega DS 800/830 that I use daily to cycle to work. Unfortunately, the swinging arm bushes are knackered. I have had no luck in sourcing any. Does anyone out there have a set (or two)?
Rich
 
Re:

It's possible they're not available as a spare, if it is a bush and not a bearing.

Probably not the answer you were hoping for, but I have the rigid frame version FS730, 18.5" i think, which i keep meaning to build but never get round to it, i'd let it go for £20, if you're interested. (Postage TBC) Everything should swap over easy enough. I also have some matching Rst forks and seatpost to fit.
 
Re:

I might be able to help you on this one, friend.

Leave it with me, I'll get back to you on Monday as I need o check they're the correct ones and they're at work
 
Re:

Is there any chance of getting a photo of the pivot?

Because we have four seperate kits.. one for the DS series, one for the RAM series one for the dual action series and one for the team series...

So I need to narrow it down for you :D
 
Hello....again
I think I have included a photo of the bush.
Richard

Total width installed is approx 64mm
 

Attachments

  • univega bush.JPG
    univega bush.JPG
    33.5 KB · Views: 514
Re:

Hello there.
I measured as best I could last night and have done a sketch, hopefully enclosed.....
 

Attachments

  • BIKE BEARING.JPG
    BIKE BEARING.JPG
    46.9 KB · Views: 473
Back
Top