The one and only "HOW MUCH IS MY xyz WORTH" thread

[elPedro666]

1/18 threaded steerer tube Project 2's
Good condition, haven't cleaned properly yet.

Roughly £50 I think, short threaded steerer limits appeal.[/quote]

Steerer I'd guess is 143mm, so up to 17" frames I think. I'd say much less I'm afraid, they're not tb so about £20, if the headset's good could be another £15.

EDIT

That hanger's worth about a tenner as well (I'd give you a fiver if you can't be bothered advertising! ).

So getting closer to agreeing now probably £35 as a bundle.

 

[elPedro666]

6mm cable ferrules for fat 2mm brake outers; may have a few of these I could part with - are they generally hard to come by? Took me a while to find any!

Quid a piece maybe, or is that excessive? Or a bargain?!

Cheers!

 

[Twister]

Rockhopper 1997?

I saw this on Friday. It needs a clean but seems almost unmarked. Any ideas what it's worth/I should offer for it?

Also, anyone got a catalogue for it.

 

[coomber]

Re: Rockhopper 1997?

I saw this on Friday. It needs a clean but seems almost unmarked. Any ideas what it's worth/I should offer for it?

Also, anyone got a catalogue for it.

Its a 1997 - catalogue should be on the archive section?

About a tonne I reckon. They seem to go cheap, but are lovely frames.

If you do end up buying and that is a 19" frame, might be interested in the forks if you end up going full bounce.

 

[Levin]

Zaskar would be about £80-100. Disc tab wont add much or take it away from that. I note it has a dent in the chainstay on the non drive side by the looks of it?

Anyway, the Z2s will make £50-70 on their own as well, so if you do both as a bundle I would expect £150.

Good luck.

Thanks for the valuation help. Now I know what I might have lost I was forced to sell this stuff for quite cheap because I am moving, and there is not much demand for this retro stuff here Finland.

What puzzled me was this: does this model of Zaskar 1993 have a slight bend on the seat tube where the seat stay goes next to it and is welded on to the seat tube as illustrated in the following picture. The slight bend is towards the center of the frame as illustrated.

Is this a result of stress or a manufacturing result?

 

[Kona-Ian]

1/18 threaded steerer tube Project 2's
Good condition, haven't cleaned properly yet.

Roughly £50 I think, short threaded steerer limits appeal.

Thanks Pedro,
Just found out they are just normal P2's.
They came from a Hahanna.... so this will change things I bet.

 

[REKIBorter]

1994 Cannondale Killer V-900

LX groupo and Coda kit

What do ya think?

 

[elPedro666]

1994 Cannondale Killer V-900

LX groupo and Coda kit

What do ya think?

I think it's awesome Would imagine anything £150-250, but as always that's far from gospel!

 

[mycws]

My 1935 CWS Help

Hi all, I have been doing a lot of research on an old 1935 Ladies CWS Co-op Bicycle (CWS badge riveted to the front) I have been given but I am not having much luck, All I do know is the above information and it also has W761 stamped on the frame below the Wright seat, the other information I can give is that it has rod brakes, original bell, original back reflector, single gear and also has veneer wood basket strapped on the front, all parts are freely moving but does need a restoration as has surface rust, I was wondering if this would have had a model name and is it something of value I should be putting on my insurance, Thank you for taking the time to read this and I really appreciate any advice that can be given, I have also got a few photos if anyone need to look at it, Best Regards Mark

 

[Ruscoe]

Help please value these little lots individually.

Right Folks I have a few bits for sale but would like some guidance as to the value before i place them in the classified section.

1) GT Arrowhead Alloy Frame 18" 1999 In OK condition one nasty scratch, fair few chips includes headset, Square taper BB, Seat post and clamp is it worth £40??

2) Vuelta USA Plus rear wheel including skewer, slightly out of true and paint has fallen off some of the spokes but otherwise a pretty back wheel, freehub in good nick.

3) Mavic X517 SUP with White Industries/Rock Shox Disc hub including 3 bolt rotor and skewer, Runs true and in very good condition

4)Rock Shox Disc Brake caliper, no idea if it works but in tidy condition. It has no fluid in it and it is to complicated for my pretty head!

5)Rock Shox Judy XL long travel front forks Cartridge system, Work well, double crown version (if that makes sense) bit of cable rub some light corrosion and i lost one of the allen bolts that ticghten the crown to the steerer tube easy fix but otherwise good

6) Shimano HG30-81 Cassette, 8 Speed Good Condition

7)Wellgo Alloy flat pedals loads of wear, but tough as old boots

8x3 Shimano Shifters and V-Brake levers ST-EF29 Both work fine and in pretty good condition.

9)Shimano Acera rear meach few scrapes but ok

10) Shimano triple Crank set - Altus, some of the 'Silver' has flaked off and is not cosmetically great

Photos Here, i would really appreciate your thoughts around price

http://www.flickr.com/photos/38519060@N ... 114765511/