Spare part for White Industries Aft Tracker Hub

[kasperlarsson]

I have some axle ends that just push in, they come in different widths.

Do you know what size you need ?

Yes that’s exactly what I need. Let me measure it and get right back to you!

And @slimjoe – that’s exactly the one I’m looking for as well, besides from the axle end and free hub body.

 

[kasperlarsson]

I have some axle ends that just push in, they come in different widths.

Do you know what size you need ?

It's the drive side axle end. It should have a diameter somewhere between 14,8 - 14,9 mm.

Do you have the Shimano freehub and a washer laying around as well?

Cheers,
Kasper

 

[kasperlarsson]

I have some axle ends that just push in, they come in different widths.

Do you know what size you need ?

Hello martinb.

I’m sorry I quoted juiceboxx for this answer. Did you see my post about the axle end dimension?

 

[martinb]

Re:

Hi,

I have 2 axle ends,

the larger is 10mm diameter for the bit that goes into the axle, 18.4mm for the knurled bit and approx 7mm for the bit above the widest section. total length 24mm. This is a WI part

The smaller is approx 10mm I/D 13mm O/D length 12mm. This was in my WI plastic tube with the one above.

I may have some others somewhere.

 

[kasperlarsson]

Hey martinb.

None of those are the right part. I’d suspect these are for a road hub, with that diameter? If you could look for other bits, I’d appreciate it a LOT.

 

[development_cycle]

Re:

I’ve had fantastic experience with the manufacturer in the past, have you tried them?

 

[kasperlarsson]

I have, yes. Very helpful, but unfortunately not able to provide the spare part.

 

[kasperlarsson]

Re: Re:

Hey Martin.

The axle end I'm looking for looks like on the attached photo. If you have any such thing laying around, please let me know!

Hi,

I have 2 axle ends,

the larger is 10mm diameter for the bit that goes into the axle, 18.4mm for the knurled bit and approx 7mm for the bit above the widest section. total length 24mm. This is a WI part

The smaller is approx 10mm I/D 13mm O/D length 12mm. This was in my WI plastic tube with the one above.

I may have some others somewhere.

 

[martinb]

I did just find another axle end, but its the same as the larger of the 2 pictured above.

What diameter hole ( axle) is it to go into ?

You may be able to get it turned down on a lathe ?

 

[kasperlarsson]

Re:

Goes in to a 14,8mm axle internal diameter.