Show us yer FSR's

[Grogurs]

im not sure what you mean either I've taken out one of the hanger screws which is sitting on rear mech for you- see photo, is that what you want info on?

Yep, perfect, okay.

Gotta have to change them to a standard screw/bolt, as the previous owner probably seized or changes them

Here is photos with the bolt measured up

Thumbs up! Very helpful, thanks!

 

[FST4RD]

OK after reading through a number of pages... can anyone tell me what the i2i and stroke of a later fsr, the one with the tube front end (2000ish) is?
factory linkage.

 

[flatulentgit]

OK after reading through a number of pages... can anyone tell me what the i2i and stroke of a later fsr, the one with the tube front end (2000ish) is?
factory linkage.

Mine, i think, is a 99 or a 2000 and is 6.5" i2i (165mm) x 1.5" (38mm) stroke.

 

[lowslowandold]

OK after reading through a number of pages... can anyone tell me what the i2i and stroke of a later fsr, the one with the tube front end (2000ish) is?
factory linkage.

Mine, i think, is a 99 or a 2000 and is 6.5" i2i (165mm) x 1.5" (38mm) stroke.

Amen preacher

 

[lowslowandold]

In its current state, need to sort out cutting the seat tube, re-routing the rear brake pipe, and getting it to the LBS to fit and sort out the gear cables

 

[Grogurs]

Interesting setup!

Just out of curiosity: Why a S-sized frame, when you seem a tall guy according to your seat post?

 

[lowslowandold]

No the seat post is just put in, I need to cut down by quiet a lot buddy

 

[flatulentgit]

does anyone know what is the best solution for putting on a disk break when the frame doesnthave a mount?

 

[valve bouncer]

See that queue going out this thread, through the lobby and halfway down the block? That's the queue for the Specialized disc brake adapter. Take a ticket.

 

[lowslowandold]

I have used an a2z on mine and it feels pretty secure, I am going to modified it as some point, I will ask a engineer friend of mine to weld the adaptor in place.