guymuttley21
Gold Trader
- Feedback
- View
Just removed a stuck seatpost.
Any recommendations for preparation the seat tube?
Is a Klein 91 FYI
Regards
Any recommendations for preparation the seat tube?
Is a Klein 91 FYI
Regards
Seat tube clean
- Thread starter guymuttley21
- Start date
If you haven't got an adjustable reamer costing around £60 (I haven't :cry
you could try this method which has worked fine for me in the past.
Tear some emery cloth into 1 inch strips and spiral a strip up a piece of tube/bar long enough for you to use like a file. Secure the emery at both ends with some electrical tape and rub away constantly trying your post in and out. I found the last frame I did a piece of 25mm steel conduit wrapped fitted just fine, that was on a 26.2mm post.
you could try this method which has worked fine for me in the past. Tear some emery cloth into 1 inch strips and spiral a strip up a piece of tube/bar long enough for you to use like a file. Secure the emery at both ends with some electrical tape and rub away constantly trying your post in and out. I found the last frame I did a piece of 25mm steel conduit wrapped fitted just fine, that was on a 26.2mm post.
poweredbypies
Old School Grand Master
- Feedback
- View
Or another way is to get a piece of dowl or broom handle if its smaller than your tube. Cut a vertical slot in it, push a strip of wet n dry through folding it over slightly when poking through then wrap it around it's self if its too small pack it out between layers with cloth strips you can then spin it in your hands when in the tube. Shouldnt take too much good metal away if you keep the pressure right and move it up and down the tube. If your really lazy attach it to a cordless drill on the slowest setting.
