First step was to strip the fork down.
The Mag21 tools are very rare these days (let me know if you got a set to buy
)
I had to find anothert way to separate the upper and lower tubes without the official seal puller.
The main steps are well documented but without the seal puller the only way to separate the fork legs is by removing the clip ring and pressurizing the fork until the legs separate.
I did release the air, removed the oil and then removed the clip ring.
After that I clamped the upper legs back into the fork crown, which I have secured in a work bench.
I also placed a big bucket with towels inside pretty thight to the lowers.
Towels also went around the seal area, as it will get a pretty mess without them when the legs separate.
I pressurized the legs until the seals popped out. Be aware that the lowers will shot away like a rocket !!! This is why I had a bucket with towels inside to catch the legs without flying around.
If you are going to try this do this on your own risk !
If you are not knowing what you do it can get very dangerous !!!!