For Sale Refurbished Girvin Flexstem in Fluro Yellow

[MSYT]

Hey folks.

V slowly clearing out some stuff.

I have this Girvin Flexstem. Recently I refurbished it. The steel quill was sandblasted and Cerakoted "titanium" and the stem part was stripped and powder coated fluro yellow. New decals have been applied from RetroDecals and the 4 main bolts were replaced with stainless. All in all, it's not a very tidy stem!

Ideally - I'd need about £45 for it but I'll call that posted.

25.4mm Quill
1993
25.4mm Bar Clamp
135mm ish Reach

 

[Silverfish]

Where did you get it PC’d?

 

[stocko]

Where did you get it PC’d?

I'd also like to know as i have 2 flexstems and a frame needing a fluro yellow coat

 

[MSYT]

Try Central Wheel Components in Coleshill

They "usually" have a fluro yellow and green. Sometimes a fluro pink. As i understand though they are difficult colours to source (or at least used to be) so they may not have them

 

[Fam Allen]

Pershore Dip Coating have always done a good job for me on frames and components. Friendly guys and good quality finish.
https://pershoredipcoating.co.uk

 

[DaiP]

I’ve had motorbike frames and parts powder coated by Grifs Reality Motor Works in Bristol. I know they do a multitude of colours and are happy to do bicycle frames and parts, not just motorbikes.

 

[27motorhead]

Pershore Dip Coating have always done a good job for me on frames and components. Friendly guys and good quality finish.
https://pershoredipcoating.co.uk

They look good. And do cerakote too! Will keep them noted down for future reference!

 

[fguki]

Great work. However, the elastomer dont seem to fit very well.

As I can see, there is a main elastomer and another flat (black) one under the screw and washer, right?

If you give me heights, cup inner diameters and bore, I can make fitting sets for the Girvin stems.

PM them to me!

Cheers!