Really Obvious Hope Ti-Glide Bearing Question

[NakedGav]

This is probably really obvious and I should know the answer (especially as I've done the job before :facepalm: )
I'm trying to remplace the bearings on my hope ti-glide and can't get the drive side one out.
Am I right in thinking it comes out the on the drive side as you'd expect, ie knocked from the inside out?
It seems a stupid question as I type but I've been "drifting" it quite enthusiastically and it's not budging so thought I'd check

 

[Rampage]

The service guide is still on the Hope website I think.

 

[dbmtb]

You're doing it right by the sounds of it - but they can be stubborn - particularly if the person who put it there didn't grease it first.

 

[NakedGav]

...particularly if the person who put it there didn't grease it first.

 

[FluffyChicken]

Just so you can double check.
http://www.retrobike.co.uk/gallery2/v/M ... rvice.html
and the slightly new version of the hub
http://www.hopetech.com/page.aspx?itemID=SPG167

and probably the best version (will put in the archive at some point)
viewtopic.php?p=1861806#p1861806
with extra pictures and detail.

Try leaving it on a radiator with wd40 etc on it.

I had to really welly one of mine to get the buggers out.
It's hard to give it such a hit when you know the tendency for the flanges to crack.. but it didn't