Wanted Pace RC200 F2 build parts needed - Syncros 1" stem

[charlE30]

Hi All, looking for the below parts. I'm not looking for NOS unless its priced well, this bike is going to be ridden

27.0mm Syncros seatpost 350mm minimum
1" Syncros quill stem 130/140mm 0deg rise.
Bolt on front mech for triple.
Front mech lower pulley.
Early RC35 fork bridge for cantilevers.

 

[AGT]

I have RC35 fork available. £100.

 

[charlE30]

I have RC35 fork available. £100.

PM sent

 

[fettler]

I have a few NOS Suntour front mechs, will be reasonable!
I have a silver 330mm Syncros post I'd probably let go too, otherwise its a 425mm which is a rarer beast. The internal circular bore on the square Pace seat tubes only goes down so far, you might be in my predicament where a 330 is too short but a 425 will need to be cut..... Not sure if I can bring myself to do it.
Canti bridge I may have a spare one but will have to look.

Pm me if you are still looking.

 

[ishaw]

There's a few rc35 bridges listed on eBay. They are for the 4 bolt forks, not sure if that's the version you are after.

 

[charlE30]

I have a few NOS Suntour front mechs, will be reasonable!
I have a silver 330mm Syncros post I'd probably let go too, otherwise its a 425mm which is a rarer beast. The internal circular bore on the square Pace seat tubes only goes down so far, you might be in my predicament where a 330 is too short but a 425 will need to be cut..... Not sure if I can bring myself to do it.
Canti bridge I may have a spare one but will have to look.

Pm me if you are still looking.

I'll drop you a PM about a couple of bits
Interesting to hear about the seat post situation, I know the 330mm will be too short, I will struggle if I have to cut a full length 425mm!!

 

[charlE30]

There's a few rc35 bridges listed on eBay. They are for the 4 bolt forks, not sure if that's the version you are after.

Hi, I've seen those but they are the wrong ones. Mine is a very early version that looks like a bent steel pipe!! Thanks for posting though

 

[charlE30]

Seatpost sorted thanks to RockiMtn

Still looking for the other parts