Neat ways to attach rear Maguras?

[daj]

Ok - then maybe these then ??
Not so tidy, I know....

Cheers Andy ... Might have a go with these

 

[fingers]

drill out the cable stops

:shock: :shock: Put a drill to a GT !! :shock: :shock:

Like the Cable idea fingers ...Guessing would have to cut and re-bleed the magura to thread it through? Shame ...For once they are ready to go go!!

To save threading it through the sleeve, you could fit the wire, then zip tie the hose to the wire at a few locations, then nothing'll be scuffing the frame...

 

[daj]

Sounds like a plan!!

 

[haydnw]

To save threading it through the sleeve, you could fit the wire, then zip tie the hose to the wire at a few locations, then nothing'll be scuffing the frame...

That is exactly what had been done on my LTS when I got it. Seemed to work well enough for the Maguras on there.

 

[fingers]

It was what I was considering til I got some m960 Vs...

 

[kaiser]

You don't need to bleed maggies to disconnect them from the cylinders. Download the manual, you wind in the adjuster on the lever and presto hey you can disconnect from the cylinder.

 

[fritzn]

That´s great, I didn´t know that adjuster trick.
But I don´t find bleeding that much of an issue, it´s easy.

I´m restoring an old RM Blizzard and this includes the paint job. So I decided on the BIG solution: planning to get extra hydro cable routing welded on in the style Paul Brodie did on early frames.

 

[pooky]

http://rover.ebay.com/rover/1/710-53481 ... 286.c0.m14

Really wouldn't recommend this fitting method, I tried it and found the cable part cuts through the sleeve in a very short time.