See my thread, the bike is being build up and also for mine the topcap is missing.
I have good experience with 3D printed parts and planning to print mine.
Can you use one when it works?
See my thread, the bike is being build up and also for mine the topcap is missing.
I have good experience with 3D printed parts and planning to print mine.
Can you use one when it works?
See my thread, the bike is being build up and also for mine the topcap is missing.
I have good experience with 3D printed parts and planning to print mine.
Can you use one when it works? geometry dash wave
How long have you had that 3D printed cap? Does it work well and is it sturdy? It would be great if you could print a replacement to use instead of buying spares.
Despite the fact that I've drawn 2 variations of the topcap, I haven't had the chance of actually printing them.
I've printed some Syncros topcaps and they turned out great.
I did one version of just covering the open top end,
And 1 version with a sort of overlap to prevent water from dripping in.
I happily share the STL files and I hope you can use them.
I think the neatest surfaces is obtained if you print them upside down.
