Uncle Monty
Retrobike Rider
- Feedback
- View
My odds and sods Explosif.
Size 15" C to C seat tube, but it is dropped, so 16" ish? 22 1/4" thereabouts C to C top tube. Its pretty small.
Its not pretty... But, full XTR M900 / M910 shifters. Flite Ti saddle. Mavic 231 Ceramic rims on XTR hubs. Judy forks, Horrible Thomson stem, Easton Monkey -lite bars. I think the seat post is original, rear brake cable guide and post collar are correct. Paint is bad, and as you can see, a cable stop was added at some point. It is brazed on, and could be removed. I think I have a set of Gil decals for it, and a pair of project 2 forks. RH shifter was working when it was put away - about ten years ago, It released but didn't ratchet back up. A bit of twiddling and it has started to work. I think it needs a bit of a flush out with lube to get it going again. No idea on this one - £350.00? Collect from Sussex, or I can arrange carrier at cost. At least there is no worries about damaging the paint.
Size 15" C to C seat tube, but it is dropped, so 16" ish? 22 1/4" thereabouts C to C top tube. Its pretty small.
Its not pretty... But, full XTR M900 / M910 shifters. Flite Ti saddle. Mavic 231 Ceramic rims on XTR hubs. Judy forks, Horrible Thomson stem, Easton Monkey -lite bars. I think the seat post is original, rear brake cable guide and post collar are correct. Paint is bad, and as you can see, a cable stop was added at some point. It is brazed on, and could be removed. I think I have a set of Gil decals for it, and a pair of project 2 forks. RH shifter was working when it was put away - about ten years ago, It released but didn't ratchet back up. A bit of twiddling and it has started to work. I think it needs a bit of a flush out with lube to get it going again. No idea on this one - £350.00? Collect from Sussex, or I can arrange carrier at cost. At least there is no worries about damaging the paint.
Last edited:
. Lots of pms etc. Think I undersold this.
