How do I transfer Raleigh badge?

[Cycling Hamster on Dawes]

On Photobucket this image is vertical!

Thanks in anticipation.

 

[xerxes]

Is the head badge riveted or just stuck on?

If it's riveted on, I'd remove the headset and cups from the bike with the badge, then use a half round file to file off the rivet heads on the inside of the head tube. I'd then file the back of the badge flush and use a strong double sided tape or perhaps epoxy to stick it on the other frame. If it's just stuck on, you'll have to tray and pry it off carefully.

 

[velomaniac]

Alternatively buy a plastic reproduction badge with the adhesive tape already fitted like I did.

 

[Rampage]

Should be able to lever it off carefully with a small screwdriver then glue and lightly hammer it onto the new frame.

 

[Cycling Hamster on Dawes]

Should be able to lever it off carefully with a small screwdriver then glue and lightly hammer it onto the new frame.

So is it possible to tap out the rivets/screws from the inside of the head tube so that I can reuse the holes on the new frame?

Thanks everyone

 

[Rampage]

The pins are just a tight fit IIRC.
They may be slightly splayed out at the end, but I've always been able to get the whole thing off including the pins using a small screwdriver, being very careful, working around it and taking my time.

 

[Cycling Hamster on Dawes]

Thanks Rampage

In that case I'm probably safe in knocking out pins with centrepunch on replacement bike. See 'white' dots on left headtube.

 

[Rampage]

Yes, should be.