Hope moto disc thickness

[Cloverleaf]

Late to the party, grabbed some pics of the v4 I have for comparison. I also have some non vented v2s. Are these thicker than standard hope rotors, haven't measured.

I'm ideally after a red one as the v4 I have is 203 but may be interested.

The non-vented rotors were standard thickness across the range at 2mm I think. They fit most brakes, I ran the Moto/V2 rotors on Formula R1's for a while when I was testing them as the Formula rotors are junk. The V2 rotors were all black centre for sale, the only ones which weren't were green team ones, and some blue discs they did for All Terrain cycles.

 

[dan28]

I m sure it's thicker than standard will check at weekend
I was thinking if I cracked the bleed nipple off pushed the pads back an bled the brake it would probably work..
I m not sure how much clearence there wouod be using a new set of pads though
If I was to sell it would be 35quid posted

 

[Cloverleaf]

Vented rotors are 3mm, standard are 2mm. If you're using the vented rotors on the V2 or V4 calipers then they work spot on even with new pads, but with a normal caliper you're going to struggle to both fit it in the slot and have sufficient space to get pads in. In fact most calipers don't have sufficient space in the slot to even fit the rotors. Some (not Hope) even struggle with the thicker 2.3mm rotors that Hope and Galfer among a few others sell.