Has anyone built a wheel with Hope Pro 4 straight pull hubs?

[Rob H]

I'm struggling to find the dimensions of these hubs to plug into the spike calculators. So does anyone have any experience with them? If so what dimensions did you use and which spoke calculator and where the results accurate.

 

[cce]

Seen this?

http://www.wheelbuilder.com/downloads/H ... 24-WBD.pdf

 

[bartsince1975]

Re:

I used the wheelbuilder straight pulk calculator for a set of Rond straight pull hubs and it was way off. Had to make a guestimate and reorder spokes. I'm not buying straight spoke hubs again.

 

[Rob H]

I read similar comments on other websites whilst searching for information on the hubs and reached the conclusion that at £1 a spoke I don't want to risk ordering the wrong size.