hawkhill97
Retro Guru
Aha, I'll bet that's it! Thanks for the info!
GT Outpost Trail
- Thread starter hawkhill97
- Start date
Aha, I'll bet that's it! Thanks for the info!
hawkhill97
Retro Guru
Had a closer look at the old BB and it is indeed bass-ackwards - as the L/R engravings show in the pic.
Never knew this was a "thing"!
Never knew this was a "thing"!
hawkhill97
Retro Guru
Headset is basic but looks to have had a very easy life. I suspect that the whole bike is pretty low mileage from the look of it.
A silver one would look so much nicer against that paint job, what were GT thinking?
A silver one would look so much nicer against that paint job, what were GT thinking?
hawkhill97
Retro Guru
Can't quite decide if this works or not! Let's see how it looks when it's fully built up...
I used to have a 1950s Raleigh Sports roadster, with super slack head angle and north road bars. Years later I wonder what it would have been like to take down a "proper" MTB trail... I suspect it would have been robust enough to survive, though the rod brakes would have been hilarious.
Very different geometry on this one, but the idea with the bars is similar, having the grips a bit behind the head tube rather than in front of it. Interested to see how it handles on the local (easy!) trails. Just messing around like a big kid really
I used to have a 1950s Raleigh Sports roadster, with super slack head angle and north road bars. Years later I wonder what it would have been like to take down a "proper" MTB trail... I suspect it would have been robust enough to survive, though the rod brakes would have been hilarious.
Very different geometry on this one, but the idea with the bars is similar, having the grips a bit behind the head tube rather than in front of it. Interested to see how it handles on the local (easy!) trails. Just messing around like a big kid really
hawkhill97
Retro Guru
Wheels cleaned up pretty nicely. I decided to use the original wheels with a 6 speed freewheel - partly because there is virtually zero wear to the rims (while my 7 speed rear wheel is pretty worn), and partly because I'm thinking the 6 speed thumb shifters I've got will suit the build better than the 7 speed trigger brifters.
A few of the spokes need another going over to remove surface rust. They seem pretty true which is good as I'm not convinced the nipples will turn freely!
Bearings seem good but since there's no rush I'll probably crack them open and re-grease.
A few of the spokes need another going over to remove surface rust. They seem pretty true which is good as I'm not convinced the nipples will turn freely!
Bearings seem good but since there's no rush I'll probably crack them open and re-grease.
hawkhill97
Retro Guru
With the rain belting down all day, I managed to make a bit more progress on this one...
Brakes and gears now set up (as well as they can be in the garage without a road test!), it's almost ready to go
Brakes and gears now set up (as well as they can be in the garage without a road test!), it's almost ready to go
