FS: Pace RC31's - £70 posted UK SOLD

[mynchiboy]

One pair of RC31's as above, I acquired these from the 'bay for the above price and they were sold to me as 420mm versions, but these be the 440mm ones :facepalm:

Steerer is 1/1/8" and a whisker under 195mm with starnut fitted. They've seen a bit of action condition wise with some scuffs on the legs, crown (mostly covered by a crown race) and dropouts but they look more than presentable and are damage free.

Pics below...they can also be collected from Central/East London for £60 if you like

SOLD

 

[lumos2000]

Re: FS: Pace RC31's - £70 posted UK

wana swap for some salsa cromots? 425mm ac

 

[mynchiboy]

Re:

wana swap for some salsa cromots? 425mm ac

Any other time yes...but I've already a replacement set of 420mm ones that handily popped up..

Cromotos are ace though, two of my bikes are currently wearing them

 

[lumos2000]

Re: FS: Pace RC31's - £70 posted UK

maybe ill hang on to them then

 

[ishaw]

Re: FS: Pace RC31's - £70 posted UK

Hi, could be up for these, and collection is possible too. Need to measure my new frame and have a question. Would 440s be suitable for a frame designed to take 90-130mm sus fork?

 

[Trousy]

Re: FS: Pace RC31's - £70 posted UK

Pm'd

 

[JeRkY]

Re:

If I were still in London i'd have snapped these up asap! (another reason to regret the move...ho hum!)

 

[mynchiboy]

Re:

Sorry for the delay in updating, I've had guests this weekend which has resulted in no sleep and too much Prosecco…

For reference the forks should be good to replace longer travel sus forks, 90mm is a bit borderline so a shorter stem may be needed to compensate. I was planning to fit them on my daily rider (Ti RSP frame) but they jacked up the front end too much for my liking. The 420's I now have are perfect

Trousy has PM'd me a firm offer so these are sold pending payment..

 

[ishaw]

Re: FS: Pace RC31's - £70 posted UK

Was hoping that pending the answer to my question, I'd take these if the answer was good. Live and learn, don't ask questions, just write pm in thread, it's all good then.