Englund / Eko Total Air Carts Help Needed

[bryanus]

Hey guys, I have some Englund Total Air Cartridge Seal rebuild kits available. These are new kits, never installed, and come with all required seals and instructions/Slick Honey lube packs. I have them for both the Black (Nylon plastic) and Aluminum (Silver) cartridges: http://tinyurl.com/totalair

Cheers!

Edit: Link fixed!

 

[Mr. Zero]

Just to finish this thread off, attached is a photo of a disassembled cart. I didn't have to remove the insert out of the rod, it was just burred over badly, so I just filed it to the same diameter as the rod so it would fit through the seals.

It's nice and simple inside with just a needle valve for damping.
I shall knock some drawings up for others future reference, and soon start a new diy damper thread.

Phil,

I appreciate that I'm resurrecting an old thread here, but did you happen to take note of the dimensions of the o-ring/seals of the unit when dismantled? Thanks.

 

[danson67]

Here's a set of Englund Eko instructions I found recently...no help with the size of O-rings, though.

All th


All the best,

 

[Mr. Zero]

Here's a set of Englund Eko instructions I found recently...no help with the size of O-rings, though.

View attachment 844076All th
View attachment 844077

All the best,

I've got this, but thanks for posting here. I intend to disassemble a pair of cartridges to measure and will post o-ring dims back here once done.