DT Swiss 350 qr conversion

[trailstar82]

Hello all,

A friend has just pulled the trigger on a set of DT wheels with the 350 hubs. Thing is he’s been sent the bolt through 15mm version, fair enough.

But finding the correct qr end caps is proving to be a real PITA.

Does anyone know what the correct end caps for the rear are?

I’ve found the fronts here

DT Swiss Front Wheel Kit for 100mm Q/R for 350

- Converts into 100mm Q/R - End caps - Please refer to the DT Swiss Tech Book for a full chart of possible conversions for wheelsets and individual hubs - Genuine DT Swiss replacement part

www.sjscycles.co.uk

 

[bikeworkshop]

If hubs are 100/135 you can buy slide in adapters with qr ends.
Halo branded in our stock.
(If they are 110, 142 you need to swap end caps, if they exist obvs)

 

[trailstar82]

Thing is by looking at the bike 2017 cannondale synapse I think he’s got 130mm spacing at the rear and dt swiss have zero conversions in that sizing.

Why is it so difficult?

Edit: have emailed Merlin and Madison for confirmation

 

[bikeworkshop]

Thing is by looking at the bike 2017 cannondale synapse I think he’s got 130mm spacing at the rear and dt swiss have zero conversions in that sizing.

Why is it so difficult?

Edit: have emailed Merlin and Madison for confirmation

You can usually adapt the adapters if you need to lose a few mm
Everything is possible!

 

[Canuk]

I had the same trouble, I ended up milling 1.5mm off each spacer works a treat.