Club Roost overhaul

[Doomanic]

If you already have the measurements for the bushes, post them here and I'll get on the case.

 

[cyfa2809]

If you already have the measurements for the bushes, post them here and I'll get on the case.

Cant find them now
Can re measure if you guys dont have a vernier?

 

[Doomanic]

I have two digital verniers and micrometers, what I don't have is any batteries...

 

[cyfa2809]

I have two digital verniers and micrometers, what I don't have is any batteries...

Will probably do it in the morning now

 

[volvot5turbo]

I couldn't bring myself to break it. :cry:

Not to worry bruv - I shall help you on that one

ps - any dibs on the forks and shock anyone.....? Not sure of their value, but I have agreed with Doom that the proceeds would be split 50/50

 

[Doomanic]

I bought some batteries for the verniers today, so as soon as I have the shock (and my new coat...) I can get measuring.

cyfa> I'd still like your measurements for comparison.

 

[cyfa2809]

yep will do them in a while. Was late this morning and having my tea now :roll:

 

[cyfa2809]

Right, got bike out of shed, shock off.

I presume your shock came with the 'sleeve' bit. i.e a central 'shaft' on which spacers/washers sit either side?

Ok,

Top end (Main frame);
Width = approx 22.57mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of shock mount = approx 11.8mm

Rear end;
Width = Approx 47.45mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of lower shock mount (stanchion end) = approx 11.8mm


About right?
Is that enough to go on?
Dont forget there are little rubber seals before the washers go on the sleeve.

 

[Doomanic]

Top Bush; http://www.chainreactioncycles.com/Mode ... delID=7466
Bottom Bush; TBA

 

[cyfa2809]

Hmm its close but the 22.2 may be just a tad small :?