cherrybomb
Old School Grand Master
- Feedback
- View
Just some bits for sale to make room.
Payment by paypal (gift) preferred but I'd accept checks and PO too.
Please allow a week for posting, it'll normally be much quicker than that but just to be on the safe side.
Oh, and I am open to offers so don't think I'll be insulted, the worst I could do is say no thanks. I'd also be interested in trades (I'm after some XT M737 8 speed shifter/levers for cantis and an M737-739 28.6mm top pull front mech.)
Canti compatible frame. A bit like a Dynatec with alloy main tubes and a steel rear end, but I'm not sure it is one.
Vital statistics:
TT 21.5" C2C
ST 16.5" C2C
BB width 68mm
SPost dia. 28.6mm (included in sale)
ST dia. 31.8mm
HTube 4.25" long 11/8" dia.
There is a small ding to the top of the drive side seat stay, but it doesn't show up in photos and shouldn't affect its usability. also some light storage scuffs but nothing major.
£30.00 posted within UKSOLD
Marzocchi XCR forks. These were NOS when I got them and work very nicely (and hold good air pressure). They've had a couple of months of light use and then been put away.
Some marking where I was a bit ham fisted removing the crown race and the top of the steerer is at a bit of a jaunty angle where I cut it but neither of these affect they're function and would not be visible when fitted.
175mm 11/8" steel steerer.
£25.00 posted within UK SOLD
Judy Hydracoil forks for V or disk brakes.
These could be used but they'd need oil and ideally new bushes. legs have been refinished in satin black.
Due to condition these are sold as spares or repair.
1/18" alloy steerer 195mm long.
£15.00 posted within UKSOLD
Orange F8 forks with 190mm 11/8" ahead steerer. (suitable for Orange frames up to 17")
Stripped for paint.
£20.00 posted within UK.SOLD
Orange alloy stem.
11/8" for standard dia. bars.
130mm with 5deg. rise.
£7.50 posted within UKSOLD
Trans-X ahead stem (11/8") for standard dia. bars. (Low stack height @ 40mm) 90mm with 10-15 deg rise.
£3.50 posted within UK
Bontrager Select seatpost. 375mm long 27.2mm dia.
Some VERY light marking to anodising but otherwise good.
£10.00 posted within UK.
Unbranded QR seatpost clamp. 35mm dia.
£2.00 posted within UKSOLD
2X M-Part carbon stem spacers (11/8") 5mm & 15mm
£2.00 posted within UK SOLD
X-Lite 11/8" top cap.
£1.00 posted within UKSOLD
Ritchey Logic 11/8" ahead set. Used but good.
£5.00 posted within UK.SOLD
Hope Fatso Ti. Front hub. 32h with black flanges.
This has a couple of hairline cracks in the flanges so its for sale for spares, for use on a wall hanger or as a paper weight.
£5.00 posted within UK.SOLD
Shimano SLR (MT62) brake levers.
Some marking to the paint on the levers but otherwise good.
£8.00 posted within UKSOLD
Deore XT (SL-M740) 8 speed shifter pods.
Very nice condition with only very light marks from use.
£30.00 posted within UK.SOLD
Pair (F&R) of skinwall Wildgrippers. These were brought NOS last year and have had very light use since. (still have the molding stubble) I don't think they've even been punchered.
£30.00 posted within UK.SOLD
Payment by paypal (gift) preferred but I'd accept checks and PO too.
Please allow a week for posting, it'll normally be much quicker than that but just to be on the safe side.
Oh, and I am open to offers so don't think I'll be insulted, the worst I could do is say no thanks.
I'd also be interested in trades (I'm after some XT M737 8 speed shifter/levers for cantis and an M737-739 28.6mm top pull front mech.)
Canti compatible frame. A bit like a Dynatec with alloy main tubes and a steel rear end, but I'm not sure it is one.
Vital statistics:
TT 21.5" C2C
ST 16.5" C2C
BB width 68mm
SPost dia. 28.6mm (included in sale)
ST dia. 31.8mm
HTube 4.25" long 11/8" dia.
There is a small ding to the top of the drive side seat stay, but it doesn't show up in photos and shouldn't affect its usability. also some light storage scuffs but nothing major.
£30.00 posted within UKSOLD
Marzocchi XCR forks. These were NOS when I got them and work very nicely (and hold good air pressure). They've had a couple of months of light use and then been put away.
Some marking where I was a bit ham fisted removing the crown race and the top of the steerer is at a bit of a jaunty angle where I cut it but neither of these affect they're function and would not be visible when fitted.
175mm 11/8" steel steerer.
£25.00 posted within UK SOLD
Judy Hydracoil forks for V or disk brakes.
These could be used but they'd need oil and ideally new bushes. legs have been refinished in satin black.
Due to condition these are sold as spares or repair.
1/18" alloy steerer 195mm long.
£15.00 posted within UKSOLD
Orange F8 forks with 190mm 11/8" ahead steerer. (suitable for Orange frames up to 17")
Stripped for paint.
£20.00 posted within UK.SOLD
Orange alloy stem.
11/8" for standard dia. bars.
130mm with 5deg. rise.
£7.50 posted within UKSOLD
Trans-X ahead stem (11/8") for standard dia. bars. (Low stack height @ 40mm) 90mm with 10-15 deg rise.
£3.50 posted within UK
Bontrager Select seatpost. 375mm long 27.2mm dia.
Some VERY light marking to anodising but otherwise good.
£10.00 posted within UK.
Unbranded QR seatpost clamp. 35mm dia.
£2.00 posted within UKSOLD
2X M-Part carbon stem spacers (11/8") 5mm & 15mm
£2.00 posted within UK SOLD
X-Lite 11/8" top cap.
£1.00 posted within UKSOLD
Ritchey Logic 11/8" ahead set. Used but good.
£5.00 posted within UK.SOLD
Hope Fatso Ti. Front hub. 32h with black flanges.
This has a couple of hairline cracks in the flanges so its for sale for spares, for use on a wall hanger or as a paper weight.
£5.00 posted within UK.SOLD
Shimano SLR (MT62) brake levers.
Some marking to the paint on the levers but otherwise good.
£8.00 posted within UKSOLD
Deore XT (SL-M740) 8 speed shifter pods.
Very nice condition with only very light marks from use.
£30.00 posted within UK.SOLD
Pair (F&R) of skinwall Wildgrippers. These were brought NOS last year and have had very light use since. (still have the molding stubble) I don't think they've even been punchered.
£30.00 posted within UK.SOLD
