Chainsets for old legs

[bagpuss]

Apart from used TA only a limited choice seems available.
Looking for square taper .
Sun xcd did made some nice 5 pin TA compatible ones a while back. I cannot find them any longer
Ideally 44/34 or smaller rings .Spa cycles sell some double touring ones that may do the job .

Anyone seen, bought anything else that may be suitable.
Running a 5 speed screw on freewheel wheel on a 1950s Carlton .
Thank you in advance.

 

[Jonny69]

Stronglight 49D fit on modern Shimano square tapers. They have 50.4mm bcd so you can put pretty much any size chainring on them. I have 48/28 on one set and 54/46 on the other. Both have TA rings. Watch out because they come in both English and French pedal threads!

 

[winjohn]

I was going to suggest Spa cycles, then read your post more carefully...

 

[Rod_Saetan]

If you can find the cranks then 86 BCD rings are fairly widely available, they go down to 26 tooth (IIRC) and up to 50+ all on the same BCD, you can run one, two, or three rings with the right bolts and spacers and BB on the same cranks.

 

[grantoury]

I have a saved search for SR Apex cranks, which came with a 94 bcd (amongst others).

 

[Glug]

I'm running Stronglight 49D 52/36 on the front on a Tange Seiki LN-3922 square taper spindle.
SunTour New Winner ultra-6 13-15-17-19-24-32 on the back - in 120 dropout.
SunTour Cyclone derailleurs front and back, GT on the back for 35 wrap.

Stronglight 49D is a very good 5 pin and the rings are TA Cyclotouriste which you can still get new: https://www.veloduo.co.uk/products/...50-4mm-80mm-pcd-alloy-chain-rings-inner-outer.
TA Cyclotouriste rings come in outer: 52-40 + inner: 42-26

Gives me 52/13 for downhill or flat and 36/32 for hills which is pretty low.

 

[petgel]

Apart from used TA only a limited choice seems available.
Looking for square taper .
Sun xcd did made some nice 5 pin TA compatible ones a while back. I cannot find them any longer
Ideally 44/34 or smaller rings .Spa cycles sell some double touring ones that may do the job .

Anyone seen, bought anything else that may be suitable.
Running a 5 speed screw on freewheel wheel on a 1950s Carlton .
Thank you in advance.

Sugino XD will do the job in double or triple. I have a spare triple set you can have for £20 shipped

 

[bagpuss]

Thank you all . I may of found one for one project I have going on . I am moving on a campagnolo gs chainset, at 52/42it is to big a gear for me now to pedal on a long ride.
Also moving on a Williams double cottered c /s again it is over geared for me now .
Looks lovely on the bike but pedalling it is another thing.

When I have removed them from from their respective mounts I will list them in the components for sale thread .

 

[KermitGKona88]

Have you tried SJS cycles?

 

[Mark Manley]

I have a saved search for SR Apex cranks, which came with a 94 bcd (amongst others).

They also do 86 which is my favourite as I run 36 tooth on most bike I own, you can also get their 118 bcd in 36 but they are rare and mine are wearing out.