Bottom bracket all sussed out and then it turned up...

[hank_marvin]

Evening people,

First post and I'm after help...sorry.

Rebuilding an old mountain bike and out of course I decided to replace a few things including the bottom bracket.

It came with a;

Shimano
BB-LP27
68 XA
BC 1.37 x 24
Not printed on it but its 111mm spindle to spindle.


I purchased a;

Shimano
BB-LP27-E
68 XG
BC 1.37 x 24

Same size spindle. But the main body is about 3mm longer than the original so if i loose fit the cranks and offer it up below the hole its 3mm further out, if i do the same with the original it lines up perfectly, where did i go wrong with my research and purchasing ? I'm guessing the BB-LP27-E is causing me issues? I couldn't find any other with a spindle 111mm and all the other numbers lined up

Other kicker is the new and old BB feel exactly the same when i spin it in my hands anyway , was half tempted to refit original and return new and be done with it.


Any help or advice would be great.

Cheers
Hank

 

[marc two tone]

Re:

E= bottom bracket mount front mech, space accommodates.

Hence the non threaded bit, next to the lip.

You can, get a hollow tech 2 spacer, 2.5mm and fill the gap, effectively.

 

[ishaw]

Re:

As above. The BB is essentially the same as your old one, just with a bit of space between the bb shell and cup to allow an e-type from mech to be sandwiched between them. Fill with a spacer and you should be fine.

 

[hank_marvin]

Thanks both!

Something like this https://www.ebay.co.uk/itm/283790003411 ?

Will I have to make allowances anywhere else on the chain line because of it?

And my original BB, is there basically no like for like made now?


Thanks again

 

[FluffyChicken]

Re:

110mm axle.

look for an MM110 stamped on the axle, near the cup, maybe. or on the shell.
I don't think 111 mm has one, may be MM111 (not common, 110 should.be fine)

oh and what cranks are they, maybe an FC-Mxxx number stamped on the back of the arm

 

[hank_marvin]

yeah thats right, on the inner part, mm110 although looks poor like a backwards C, on the new and old, guess its a bad punch.

Cranks are Shimano FC-MC18

 

[marc two tone]

Thanks both!

Something like this https://www.ebay.co.uk/itm/283790003411 ?

Will I have to make allowances anywhere else on the chain line because of it?

And my original BB, is there basically no like for like made now?


Thanks again

Yep. It will just snuggle against the flange, wop it in like normal, nice and firm.

Chain line wont be effected too adversely. Possibly a little out but nothing you cannot accommodate.

 

[hank_marvin]

Nice one, ordered the spacers Cheers

 

[ishaw]

Re:

I doubt the chain line will be affected. The cup is just designed to be slightly outboard with a spacer for an e type mech. The m952 bbs were universal fit for 68 or 73mm shells with spacers to take up the difference, one spacer less if running an e type mech. You should be fine IMHO.

 

[hank_marvin]

Will update once fitted.

Brakes refitted today with new inner outers and pads and new grips, getting there.